OREQA 010 EEC H2 ISO ePM1≥50% / ISO ePM1≥50% (F7/F7) BASIC

MANUFACTURING FEATURES

• Circular outdoor flange with bird guard made of galvanized steel.

Duct sensor for measuring temperature, relative humidity and CO₂ in the rooms.
Optional: The CO₂ modules can be removed from the sensor to be calibrated.

The sound attenuators are used to absorb the noise in air conditioning or ventilation ducts.

Casing in galvanised steel, thickness 0,8 mm;
Mounting flange with quick attack;
Acoustic material in mineral wool  50 Kg /m³ with protection against erosion by glass fibre fire resistance M0 and extended metal sheet

 UNDER REQUEST:

Stainless steel execution

• It consists of a kit including the 3-way valve for the control of the water flow, to be combined with the hot and/or cold water coil, and its modulating electric actuator.
• Connection and fitting devices not included (to be arrange for by the installer).

• Protective roof for outdoor.

Filtration for air treatment units equipped with a pre-filter upstream, and air-conditioning units.

• High filtration area, high efficiency, compact and economic filter.

• Media: Mini pleat fiberglass paper
• Frame: Galvanized steel

• Maximum T° in continuous service: 100°C
• Humidity: 100% RH

• Tested for food contact according to CE 1935/2004
• Certified for microbial development (ISO 846-VD 6022)

• The automatic defrost system consists of a self-regulating electric coil in PWM mode of the input power, installed on the return air intake.
• The system is controlled by a special temperature probe positioned on the exhaust air and guarantees a considerable reduction of the input power compared to the traditional systems available on the market.

All units may be equipped with an internal re-heating electric battery, made up of armoured steel electric heaters, supplied complete with PWM control system, safety thermostat already wired and installed on board.

• The hot water coils are supplied in a dedicated section to be installed in the supply air-flow line. The casing has the same sizes and features of the main unit and it is fixed with a dedicated installation kit supplied with it.
• The coil is manufactured with copper pipes thickness 0,4 mm and aluminium fins thickness 0,11 mm.
• The pipes are mechanically expanded in the aluminium fins to increase the thermal exchange rate.
• On request, it is possible to install coils with different capacities from the standard ones, when previously agreed with the factory.

• The coil is manufactured with copper pipes thickness 0,40 mm and aluminium fins thickness 0,11 mm.
• The pipes are mechanically expanded in the aluminium fins to increase the thermal exchange rate.
•On request, it is possible to install coils with thermal performances different from the standard ones, when previously agreed with the factory. The cooling coil section is supplied complete with condensate drain pan with side water discharge.